NewerTech Guardian MAXimus User Manual download pdf (Page 9)

Place the second hard drive into the enclosure and line up the screw holes on the side

of the chassis.

Using 4 of the large screws that were in the clear packet you removed from the chassis

of the Newer Technology Guardian MAXimus, fasten the hard drive to the chassis

using the upper screw holes. Insert the screws through the black rubber vibration

dampening grommets and partially tighten until you have all 4 screws inserted. You

may nd it’s easier to lift up on the drive on each end to relieve pressure from the

screws when doing this. Repeat on the opposite side and then tighten all fully.

Reach in behind the hard drive and manipulate the

combination SATA data and SATA power cable around so

that the long L shaped opening in the cable is oriented in

the same position as you see in this photograph.

Plug the combination SATA cable into the back of the

drive, making sure that it is fully seated into the drive and

also that the opposite ends are rmly connected to the

bridge card.

Look at the SATA data and

power cables that you

installed and conrm that they

are routed so that they do not

interfere with the exhaust fan.

Bending the SATA data cable (the red cable) into a U shape

as shown here keeps the cable from sagging into the edge

of the fan and is the best way to route the cable.

This is very important!

Newer Technology Guardian MAXimus Chapter 2 - Assembly

2.2 Assembly (continued)

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

No comments

NewerTech Guardian MAXimus User Manual Page 9